不锈钢轴承精度
日期:2020/10/31精度 TOLERANCE 轴承的精度包括尺寸精度和旋转精度,尺寸精度是将轴承安装于轴或轴承箱时所要求的项目,它包括内径、外径、宽度、倒角尺寸公差或允许值。几何精度包括内径 偏差、平均内径差、外径偏差、平均外径差、套圈端面平行差的允许值。旋转精度是规定旋转时振摆的,包括内圈及外圈径向摆动和轴向摆动,内圈侧摆及外径面垂 直度公差范围。 轴承的精度等级从普通级0级到6级、5级、4级及2级,依次增高,下表1是中国GB307规定的精度等级与其他标准的比较。 Bearing tolerance includes dimensional tolerance and revolving tolerance, Dimensional tolerance is a request when bearings are mounted on shafts or in housings. It includes bore/outerside diameter deviation from basic, inner ring/outer ring width deviation in single radial plane. Revolving tolerance includes radial and axial runout of assembled bearing inner ring and outer ring, inner ring reference fcace runout with bore and outside cylindrical surface runout with outer reference face. Tolerance class ranges from common class 0 to 6,5,4 and 2, from low to high, Table 1 below is the tolerance class stipulated in China GB307 and its comparison with some other standards.
部分国家轴承精度等级对照表 COMPARISON OF TOLERANCE CLASS
国别 |
标准号 |
精度等级 |
中国 CHINA |
GB307 |
0(G) |
6(E) |
5(D) |
4(C) |
2(B) |
ISO |
ISO492 |
0 |
6 |
5 |
4 |
2 |
德国 GERMANY |
DIN 620/2 |
P0 |
P6 |
P5 |
P4 |
P2 |
美国 USA |
ANSI B3.14 |
ABEC1 |
ABEC3 |
ABEC5 |
ABEC7 |
ABEC9 | Tags:不锈钢轴承
阅读上一篇新闻:轴承游隙
阅读下一篇新闻:推力轴承 |